Zip Line Tension
Cable tension can be a large factor in the installation and performance of a zip line. It affects the speed and altitude of the rider, as well as the amount of strain the zip line puts on the anchor trees or poles.
Speed: A zip line with a higher cable tension can start slowly but will accelerate throughout the ride and maintain speed through to the end. A zip line with lower cable tension will start faster, but can easily run out of speed towards the end. Think of a marble dropped into a large bowl; staring out quickly as it drops into the low point, but slowing down as it has to travel uphill over the second half.
Altitude: The tension of a zip line cable directly affects the height at which a rider will travel above the ground. Tighten a cable to get them a little higher; give it slack to bring them lower. Keep in mind that height adjustments on your anchor point can also raise or lower the riders path.
Anchor Strain: A riders weight can be multiplied several times when placed on a horizontal cable between two anchors and this effect increases with higher cable tension. Be sure your anchors are sufficient to withstand the sheer loads and follow your installation guidelines carefully to prevent over-tensioning your cable. A good rule of thumb is to make sure your cable (while being ridden), hangs below the ending anchor by about 2% of the zip line's length. So the trolley on a 100' zip line should be, at its lowest point, about 2' lower than where the cable is anchored on the lower end.
Achieving Tension: For most zip lines 100' or more in distance, achieving proper cable tension by hand can be a real challenge. We recommend using a Tensioning Kit or a similar type of winch to crank your zip line tight. If you already have a come-along winch, adding a Cable Grab to the end of your existing setup could really make this process much easier.
Speed: A zip line with a higher cable tension can start slowly but will accelerate throughout the ride and maintain speed through to the end. A zip line with lower cable tension will start faster, but can easily run out of speed towards the end. Think of a marble dropped into a large bowl; staring out quickly as it drops into the low point, but slowing down as it has to travel uphill over the second half.
If your zip line ride as a whole is a bit slow, tightening your turnbuckle just might do the trick. If it's running a little fast and hou have some room to adjust, try giving it some slack.
Altitude: The tension of a zip line cable directly affects the height at which a rider will travel above the ground. Tighten a cable to get them a little higher; give it slack to bring them lower. Keep in mind that height adjustments on your anchor point can also raise or lower the riders path.
Anchor Strain: A riders weight can be multiplied several times when placed on a horizontal cable between two anchors and this effect increases with higher cable tension. Be sure your anchors are sufficient to withstand the sheer loads and follow your installation guidelines carefully to prevent over-tensioning your cable. A good rule of thumb is to make sure your cable (while being ridden), hangs below the ending anchor by about 2% of the zip line's length. So the trolley on a 100' zip line should be, at its lowest point, about 2' lower than where the cable is anchored on the lower end.
Achieving Tension: For most zip lines 100' or more in distance, achieving proper cable tension by hand can be a real challenge. We recommend using a Tensioning Kit or a similar type of winch to crank your zip line tight. If you already have a come-along winch, adding a Cable Grab to the end of your existing setup could really make this process much easier.